power_on via at+ckpd?

  • Thread starter Thread starter phesx
  • Start date Start date
P

phesx

Guest
hi to all,
I have two questions and thanks in advance for any info:
1) do you know if it is possible to power on a phone using the AT+CKPD command? (obviously I intend to power the phone using the accessory connector with a cable with power supply pin and RX,TX)
2) I have an old C45 and the AT+CKPD is not supported (It seams supported on the sl45??) . Do you know if c55 or c65 or greater will support this commad?

ciao
 
hi, thanks for the answer
just to clarify I would give power to the phone via the connector. so at the end the phone is powered (I use an RX-TX cable with power) and my question is: can the at+ckpd works in this way?
thanks in advance
 
It is possible to power on Siemens phone only via cable.

In Martech Software you have got a button which do it.
It gives an ignition signal and ..... don't ask me what else.

S-Gold phones are powered on in Service mode first and then from service mode to normal power on mode
 
Back
Top