If I apply +12volts to the fuel pump relay the truck will start, so the fuel pump works. Was wondering where the 12 volts to that relay came from. - I know the Fuel pump works. I cleaned the grounds too.
Fuse is fine. Apllied 12 volts before the fuse and pump runs/truck starts. Diagram shows on Relay a constant 12 on A-pin that is there. But no 12 on the energize line of that relay.
When I put 12 volts on the Energize line of relay I can hear the relay click and fuel pump start.
Fuse is fine. Apllied 12 volts before the fuse and pump runs/truck starts. Diagram shows on Relay a constant 12 on A-pin that is there. But no 12 on the energize line of that relay.
When I put 12 volts on the Energize line of relay I can hear the relay click and fuel pump start.