Hey so I just purchased a lincoln pro mig 180 and I plugged it in and ran the wire through made sure the ground cable was tight to the clamp and the gun trigger connector receptacle in and everything then when I went to weld nothing would happen the wire just came more and more and nothing so then I touched my welder to my ground clamp and it sparked but only if I touched it to the ground clamp. Then when I looked in my gun trigger connector it only had 2 pins for some reason though there were 4 slots.
Whats the problem
* Iam doing flux cored welding no gas* * The welder comes out of the box ready for flux cored* so polarity is screwed tight
Whats the problem
* Iam doing flux cored welding no gas* * The welder comes out of the box ready for flux cored* so polarity is screwed tight