I installed a custom intake for my 1995 buick skylark.?

F

Frankie

New member
I just installed an custom intake for my 1995 buick skylark. After that it was running fine. Now when i put in a new front o2 sensor it has trouble at idle only when i start it. It starts fine then the rpm's drop below 1000 and it starts to studder and either it shuts off or the rpm's kick back upt to about 2000 rpm and its fine to drive. what might be ther problem. the engine is a 2.4l quad 4 thanks
Cold air intake is what im mean by intake and this is the second o2 sensor ive tried
I checked and there was no mas air sensor on the intake. The only thing attached to the intake was the vaccume hose. then its atached to where the o2 goes into the engine. thanks guys
Ok will do. Thanks guys. again
I went back over the cold air intake setup and found that it could be a leak, not tight enough. Im going to try it again. ill let yall know.
 
I would say the o2 sensro stated by the other person beacuse you dont have the computer that monitors the fuel/air ration beacuse its carbureted if im right.
 
Sounds like the o2 sensor is faulty or if you have an ECU maybe that is damaged. It is something with the electronic management system that decides how much air and how much gas goes into the engine. Get it fixed ASAP or you could have serious problems.
 
Back
Top