I have a 94 ford ranger v6 3.0 it cranks but it wont start?

  • Thread starter Thread starter mossyoakgirl6564
  • Start date Start date
M

mossyoakgirl6564

Guest
I recently replaced the clutch slave cylinder and the clutch master cylinder. After that I replaced the ignition control module, ignition coil, and distributor cap. It still wont start. I need help?
 
check to see if ignition module is sparking. pull a plug wire, if it has one and lay it next to plug have a buddy try to turn. if it sparks your ok if not then get it tested. If you get it tested have them test it about 10 times and if it fails once get a new one. I had that problem with the module before. it pass 5 times before 1 fail. everything above you did should rule out alot of things it could be. not your ignition switch because it cranks. check plugs, check wires may accidentally crossed. check to see if you have gas. check fuel filter, may be clogged. fuel pump may not be pumping and pressurizing system to turn over.
 
Check fuel pressure and compression in each cylinder. Also can be crankshaft position sensor.
 
Back
Top