i just got done flushing the master cylinder reservoir and both front break lines with new DOT3 brake fluid on my dads 1998 Mazda B2500 LE do to the fact the fluid was almost oil like. now my question is how do i do the rear brakes? there is two hard lines going in one is silver metal about 1/4 inch around and one is black hard rubber i believe and its closer to 3/4 inch around the both go directly into the brake assembly unlike the front (having just a bleeder bolt to connect it) do i have to remove the whole drum brake assembly?
note there is a bleeder nipple right above the small of the two lines but its more like a slave cylinder bleeder valve. i have a feeling this will not drain brake fluid, but i could be wrong.
note there is a bleeder nipple right above the small of the two lines but its more like a slave cylinder bleeder valve. i have a feeling this will not drain brake fluid, but i could be wrong.