On the bellhousing is a slave cylinder with a small bleeder valve sticking out on it.
You need someone to get in the car and pump it a few times and then hold it to the floor and then you break the valve loose with a small wrench,but watch out for the brake fluid that will spurt out,keep the clutch to the floor at all times when this is open or you will suck air back in the valve and you will have to start all over.
Make sure the clutch resivior is full after a few times it should come back to normal. Most cars use dot 3 brake fluid.and dont get it on the paint it will eat it up.
Hope this helps.
