How to avoid/get rid of drips when sparying a car?

  • Thread starter Thread starter pathwalker
  • Start date Start date
P

pathwalker

Guest
I'm spraying my car with Spray cans (I know a gun is better but can't afford it) But I keep getting drip marks. How can I stop this?
 
dont apply so heavy just apply numerous dust coats untill areas are covered starting at botom of each panel working up and going right acoss the full panel turning your wrist out ath end of each panel where it meets the next panel dont stop mid panel .to get rid of drips sand down with fine sandpaper(600-800 grit wet and dry sandpaper) till smooth(rubber rubbing down block helps here)if your respraying full car your wasting your time use lots of aerosol and will look like soomeone who didnt know how to paint did .one maybe two panels might not look so bad
 
Back
Top