How do I switch out the distributor rotor on an 86 toyota corolla?

  • Thread starter Thread starter childofgod7
  • Start date Start date
C

childofgod7

Guest
I am trying to change my distributor rotor on my car. In my repair manual it says I should be able to pull it off but I can't. I have also tried twisting and pulling which one repair website suggested to do and it does not seem to be coming off. Are there any tricks that make it easy or should I just leave it to a mechanic?
I was told not to use something (like a screwdriver or a pry bar )to pry it of with because it could wreck the distributor that the rotor is attached to.
 
Use a vise grip and set it so that it just cracks the rotor where it goes over the shaft. Then pull straight of. Good advise not to try and pry it of as you run the chance of breaking the side of the distributor.
 
On that toyota there should be no screw. Just a straight up pull. it`s good you stated not to pry it, not good. but you can to try to grab the end tabs (one has the electrode other just a wing) and rock it while pulling up. no luck? try a pliers or channel lock pliers and still pull straight up while rocking if needed. When/if it comes off there will be a round shaft exposed with one side flat spotted,this is so you can not put it back on in the wrong position. Good luck Girl!
 
Back
Top