Casual Catastrophe
New member
I just finished up measuring and marking out the locations for the Gen Right hood louvers for my Jeep Wrangler. Tried my best to find a good center line down the middle of the hood and base all side to side measurements off of that center line. I just used the rear edge of the hood for all front to back measurements since it's a nice straight edge. Just want to make sure it looks alright before I start cutting and drilling holes all over in my hood (aah scary!) it's now after 1 a.m. here and I've been working on those lines for close to 5 hours so I don't trust my eyes right now to catch a problem!
Here's the pictures
http://s639.photobucket.com/albums/uu116/dasfrettchen/Album%201/
.. and yeah, I'm going to take the time to make those dark crisscross lines in every hole that is going to be cut out.. because I know me and if I don't do that then I will undoubtedly make a cut closely followed by "Oh god.. what did I just do?!?! F*CK!"
Sorry, just realized this is in the wrong category.
Here's the pictures
http://s639.photobucket.com/albums/uu116/dasfrettchen/Album%201/
.. and yeah, I'm going to take the time to make those dark crisscross lines in every hole that is going to be cut out.. because I know me and if I don't do that then I will undoubtedly make a cut closely followed by "Oh god.. what did I just do?!?! F*CK!"
Sorry, just realized this is in the wrong category.