yesterday that car was shifting perfect on park to drive and etc..
but last night i did a tranny fluid change and i only added 4 quartz and i turned it on and i shift to reverse to pull it out so i did but when i put it in drive with was just reving and after a few minutes it would shift while i stepped on the accelerator and when i drove down the block did a u turn back it felt like it wasn't holding the gear in and luckily it did so i put it back in the garage and it shifts on flat ground perfect drive to reverse etc.. but when i am backing out in reverse its like a downhill and when i get down i put it in drive it won't go why is that ? i didnt mess with the modulator while i changed the fluid and its a tci 400 and the shifter is a star b&m and i just unbolted the 2 bolts as i was unbolting the pan bolts to change the gasket and fluid and filter and i didnt mess anything i just bolted everything up torqued it down and i bolted the bracket where the 2 bolts of the shifter plate needed to be bolted as instructed on the shifter to the transmission pan and i didnt remove the cable just the plate that holds the cable to the transmission pan. do i need to add more than 4 quartz to shift properly i only added 4 quartz
but last night i did a tranny fluid change and i only added 4 quartz and i turned it on and i shift to reverse to pull it out so i did but when i put it in drive with was just reving and after a few minutes it would shift while i stepped on the accelerator and when i drove down the block did a u turn back it felt like it wasn't holding the gear in and luckily it did so i put it back in the garage and it shifts on flat ground perfect drive to reverse etc.. but when i am backing out in reverse its like a downhill and when i get down i put it in drive it won't go why is that ? i didnt mess with the modulator while i changed the fluid and its a tci 400 and the shifter is a star b&m and i just unbolted the 2 bolts as i was unbolting the pan bolts to change the gasket and fluid and filter and i didnt mess anything i just bolted everything up torqued it down and i bolted the bracket where the 2 bolts of the shifter plate needed to be bolted as instructed on the shifter to the transmission pan and i didnt remove the cable just the plate that holds the cable to the transmission pan. do i need to add more than 4 quartz to shift properly i only added 4 quartz