CAn anyone help?? Im tryin to remove the broken wheel studs from my honda civic?

  • Thread starter Thread starter Jose
  • Start date Start date
J

Jose

Guest
i have already removed the caliper and the big nut in the middle of the rotor and have also removed the rotor, i tried bangin out the boken studs but dont come out due to the back of the hub so now i have to remove the hub how do i do that can anyone help ialready tried the puller but its just not doin it.....thanx
 
As you turn the hub around, there may be a position where there is a slot behind the stud to allow it to push through. I haven't looked at the Honda, but that's how many cars are. The auto repair manual will tell for sure. Chiltons makes a good manual. Look in the book before you take off the hub- if it will come off without a hydraulic puller. Good luck.
 
Front or back? If it is the front, try removing the sway bar links and disconnecting the bosses. This should allow you to move the hub around an gain access to the back of it. Than just remove the cover plate. If it is the rear, then try using some penetrating fluid. While you have the puller on it, give it a few whacks with a rubber mallet on the sides.
 
Back
Top