c72 can't connect

  • Thread starter Thread starter jatjag
  • Start date Start date
J

jatjag

Guest
I used ufs cable & usb to serial converter to connect c72.I can read phone info IMEI etc.means cable is o.k but when I use it with papuautils in fash mode selecting pause & replace options clicking dojobs it says autostart ,boot not loaded,boot unlock & process stops .I have connected t.p to gnd with 33 ohm resistor.attached full charged battery but always says same error .what is wrong please help
 
..to working in the Flash menu from papuautils, need to your phone to be off (not in service mode). After check options, click on Do the Job and push shortly On/Off red button from your phone (or touch the two pins of the keyboard PCB connector).
Note:
- not in working this this menu only if you know what you want to do...
- testpoint options is used only if your bootcore is damaged or write the new bootcore...
dagos
 
...to unlock your mobile not needed TP.
Just check "??????OTP", "Recalculate Keys", "Pause" and click to "Do the Job". See in the "Codes" menu if you have write IMEI and SKEY). If not, write any 8 numbers (for SKEY).
dagos
 
please I don't understand how to unlock network and phone code for c72 with mobilex beta v3.0 beta 1.3b ?
is there any manual for the soft and could you explain step by step for siemens c72 ?
thank very much. Sorry but I'm a new user
 
Back
Top