Big Problem

  • Thread starter Thread starter Wyshniukas
  • Start date Start date
W

Wyshniukas

Guest
I got one dead SL45i. Tried to write the fubu using Freia,but it shows only this error:
COMM_NormalWriteFlashBlock : erase error at 00A20000
COMM_NormalWriteFlashBlock : writting error at 00A20000

Using V_Klay also shows "Error corrected: 1"
UNISiemens writes fubu, but the phone is still dead
Anyone can help me with repair solution?!

Thanks
 
After reading your text file I see you have a deep wrong step. That is you wrote a FUBU of v54 to a v55 phone.
Try somes solutions:
1. You have to write you origin FUBU v55 (if you have a origin firmware backup), maybe it's take much time;
2. You have to find a Winswup for downgrading to v54 or upgrading to v56;
3. Try to search and download a FUBU of v55 then write it to your phone (It can make your phone have battery problem, you can search in this forum about sl45 battery problem, almost of them come from writing non origin FUBU into phone). In order to overcome this, first you should backup eeprom of your current firmware (size 64 KB), then you write another FUBU , finally writing origin eeprom to phone (maybe you also repaid "Wrong Software" problem - you can search in this forum about repair this problem).
Good luck!
 
this is evidence of your wrong way (extract from your text):
COMM_LoadBoots : found SIEMENS SLIK lg1 v55 (1)
COMM_LoadBoots : flash ids are 008988C2 [008988C4] - C489
COMM_LoadBoots : phone ids are 6AFD3CAB [6AFD3CAB]
COMM_Write : using C:\IMPORTANT\SIEMENS\FREIA 10\SIEMENS SLIK LG1 V54 - 00A00000.FLS
 
@sl45vietnam

1.I don't have original FUBU, because I got phone with patches & non original sw.
2.Winswup detects phone, but after 5seconds shows "Aborting due to transmission-error"
3.Downloaded Sl45i v55. Tried to write it with UniSiemens & zSiemens by RizaPN, but problem is still like in first post.

Spoted that with zSiemens stuck for few seconds at 300000, but later writes fubu Perhaps Martech box could help?! What do you think?!
 
Pls try to use V_Klay many times, keep be patient!
Moreover, you can use another cable, maybe current one has some problem.
 
Why you say so? Did you had any problems with it?

@sl45vietnam
Ok, I will try with V_Klay & other cables
 
Asked avkiev about V_Klay correting error. he said that's ok, now never mind at it )
 
Sorry, it's to difficult to know why for me! I think maybe your phone have some hardware problem. What did avkiev said to you?
 
I asked him about the error showed on the end of writing[Error corrected: 1]. He said that never mind, if it's corrected that means corrected Found one repair center, which has a Martech box...I will take them my phone.
 
Back
Top