All cable's pinouts for chines Mobiles

I have infinity and pin-finder one china goldmobi model j700 automatic dead but i have pin-finder cable lo5b not support select cable type.brother help me
 
Hello,

I bought infinity box whis 150 cables but not cable I need.

I need pinout for model Mini KA08 ET KA09.

and I also have another question.
I ordered pinfinder infinity box whis 23 cables (I wait it).
My question:
if I find the pinout of my phone with a supplied cable (pinfinder box), can I do a read of the firmware with the same cable but whis infinity box .or should I use a other cable whis this pinout (or make a cable with the correct pinout)? ?

Can anyone explain this (as if I was 6 years old for well understand)?

Pleaaaaaaaaase help me-thanks

Christophe from france
 
I need the piinout of the Cesim V800..
I don't want to know where is the Rx and Tx pins. I want the VCC, GND, USB DATA+ and USB DATA- pins..
Could someone unscrew the mobile connector and see it for me, please?
 
Found pinout for KA09 with my multimeter :-)

1 - Charge (+5V)
2 - Vbat
3 - Tx
4 - Rx
5 -
6 -
7 - USB Data-
8 - USB Data+
9 - GND

10,11,12 are for headset (non tested, will be done in future, maybe...)

Under battery cover, near SIM1 socket, are "test points", labelled (from top...) RX, TX, PWR, GND, VBAT and CHG. These points i measured with pins in connector and found right pinout for flash cable. Other pins i add from USB data cable and headset. Note that RX and TX are taked out through 1000 ohm resistors.

Hope this help to anyone
 
Hi , i am searching for (Daxian) D-Six N97+ dual sim usb cable port. the usb cable charger pin out is 2x6 12 pin Micro-B connector. is you can send the pin-out diagram and cable colors is good for me and sorry for the short previous post. also the usb cable is deferent from the normal N97 original the one that i am searching is with 2x6 12 pinout connector. Many Thanks for this forum post
 
Back
Top