Hello all, I have a 90 Ford Bronco, 351. Just put the intake and air plenum back on. New plugs, wires, rotor, cap, distributor, coil, fresh gas & oil change. Said to be a rebuilt motor was seized at first oiled the cylinders and turned over about 4 hours later. compression check 2 cyl. at 60 psi. it did start long enough to burn out the oil from the cyl. replaced the plugs and it wont start. the compression has came up a little in the 2 cyl. that were at 60 psi...asuming the rings are seating if in fact it is a rebuild eng. Still wont start. gap at 44.
90 Ford Bronco wont start, please help!?
- Thread starter Bronco
- Start date