2700 installation help!

  • Thread starter Thread starter Dylanyah
  • Start date Start date
D

Dylanyah

Guest
I know this is an dinosaur
but it was given to me + the dish with lnb
so having a multi sat dish with 1 lnb i decided to make use of them
So i set them up 2 lnb put the dish to the approx. angle and did connections
But once setting them up i tried to tune in sat signal it was red 0 even tuning the signal in with a sat finder didnt help i was pretty sure i had it locked in but still at red 0

So what to do- should i try with one lnb and the single dish
Likely that it wont
 
Red/0 means you are not pointing correctly (and/or you need to clear the check switch setting or have numerous other possible hardware issues).

Pointing a dish is not usually done by just guessing since you are trying to point your dish at a 20 foot object 22,000 miles away. :)

Check out this thread as it provides many pointers on setting up and aligning a dish.

http://www.digitalhome.ca/forum/showthread.php?t=16447

Either dish should be fine, but if you setup a dual, then follow the directions and set 91 first.
 
Back
Top