yes we did,the wire wasn't long enough to reach but that was the only major change we had to do,but cranking it over for long periods of time can kill the plugs in it and make it not start,id try changing the plugs real quick in it,that should make it fire right off,it will miss and sputter a few times when it first starts but it will clear up and run smooth,ours spit and sputtered for a few minutes then cleared up and we have had no complaints from the customer yet on it,and this has been well over a month now,if you get the plugs wet before it gets fire to them it will kill them,so id try changing those,good luck.PS when you first start it you,ll get a check engine light come on,ignore this until it warms up,this should go off after about 15 minutes of running,ours did,then we erased all codes and it has ran good since then.