Corey Phipps
New member
When I push in the clutch it wont go in gear. So when I start it in gear it starts trying to take off as I crank. To shift, once I start driving, I have to match revs or it wont go in gear. I just replaced the slave cylinder and bled it several times but it is still acting up. I don't hear any funny noises and the feel on my clutch pedal sucks (feels like it takes hardly any pressure to push down). Last time I ran into a problem like this it was the dual mass flywheel on my 03 tiburon when one of the sides of the flywheel had some play in it. Do the 1983 rx7's have a dual mass flywheel? Does anyone have any ideas otherwise? All help is appreciated!
Im pretty sure I have adjusted it as far as it will go. It did start catching high on the pedal before I had this problem anyways so it may just be time to replace it. But it is not slipping any when I do drive it. I just finished brake torqueing it because it ticked me off
Im pretty sure I have adjusted it as far as it will go. It did start catching high on the pedal before I had this problem anyways so it may just be time to replace it. But it is not slipping any when I do drive it. I just finished brake torqueing it because it ticked me off