03 ford focus stick wont go into gear PLEASE HELP?

C

Cora

New member
i replaced the throw out bearing and clutch disk and master slave cylinder and bled my clutch a few times. and it still wont go into gear n when i push the clutch down it makes this chatter type noise..please help i havent had my car for like 2 weeks and cant think of anything else to do and cant afford a mechanic..any ideas will help
its a hydraulic clutch. the pressure plate wasnt bad..any other answers..please help..this is frustrating.
 
I assume you installed a new clutch kit, preferably a reputable one like Luk and had the flywheel and pilot bearing replaced. Its not the master or slave, it sounds like it wasn't done correctly or done properly. Take it apart and try again having clutch doctor come out and resurface the flywheel and replace the pilot bearing. Did you use a clutch alignment tool? Question is kinda vague.
 
Does the clutch pedal feel right, or does it go a long way down before disengaging? There should be very little pedal movement before you begin to feel resistance. See if the slave cylinder shaft to the throwout fork has an adjustment on it. If it's noisy when you depress the clutch, then something's wrong with the throwout bearing or clutch installation. How does it shift with the engine NOT running? Does it feel like the clutch is disengaging properly? Maybe you need to bleed it some more. Hope some of this helps.....
 
Back
Top