Search results

I know they adjust sharpness but in what ways ? Thanks.

Yes,they should check the camber at the same time.

Yes,they should check the camber at the same time.

Yes,they should check the camber at the same time.

A coded key only,at dealership can cost around $150. they are fitting a new cylinder and housing you could check on the prices of these parts i believe they come as one kit(switch)key included. you could have it replaced by you friend but will he have the equipment to code,unless you have it...

Yes oem are best in all condition rain,dry weather,heat. You will need axle stands a 14mms ring spanner,a G clamp to push the pistons back and brake bleeding tools as the bleeders will have to be loosened as pushing pistons to avoid damaging abs.

Most clutch pedal have springs to hold them high this to allow a few mms in between the pressure plate and clutch bearing. These spring pull. The pressure plate has springs to allow the centre plate being freed it also helps to push the pedal high. If your clutch cable is broken the pedal will...

Most clutch pedal have springs to hold them high this to allow a few mms in between the pressure plate and clutch bearing. These spring pull. The pressure plate has springs to allow the centre plate being freed it also helps to push the pedal high. If your clutch cable is broken the pedal will...

Most clutch pedal have springs to hold them high this to allow a few mms in between the pressure plate and clutch bearing. These spring pull. The pressure plate has springs to allow the centre plate being freed it also helps to push the pedal high. If your clutch cable is broken the pedal will...

A quick check of the charging rate will pin point the fault.

Four hours labour sounds fair.

Four hours labour sounds fair.

The gas tank has broken partitions it could be cut opened and repaired or replaced this is common on Isuzu.

It could be due to low levels or electronic components fault(s)

The carburetor should be removed taken apart,left overnight in carb cleaner liquid,rinsed with water and then air pressured in each air and fuel passages. The needle valve and mixture should be adjusted as per maker specifications.

Think you have to contact your nearest Suzuki dealer. Or try ebay.