Search results

...out at the same time? One day my truck stalled I put gas in the other tank then it stalled too.I have electronic pumps to each tank what else could it be?

My truck is a ford f-150 with a 302 fuel injection 2 wheel drive with auto tranni.When I start my truck it runs good then I put it in drive and it stalls.After I drive for about 20 minutes it runs ok. But if I start it and drive slow it stalls.Could it be the idle valve- it runs ok on neutral...

My my tranni is going bad if I pull one from the wrecker how do i know if the tranni is good nny going out I can feel it.If i get one at the auto wrecker how do I know if the tranni I'm pulling is good?if I pull it and take it to a mechanic can they tell if its good?

When I turn my heater on it doesn't heat and it smells like something burning also the lever in the heat control panel that pulls the wire feels like it stuck.

when I'm in drive going about 20 miles an hour my tranni jerks I can hear the linkage go clank it only does it till i go 50 miles or faster.Then when I slow down it does it again.When I drive in the second drive witch is one space down on the shifter it doesn't do it as bad but I can't get over...

So both the battery and the alternator are bad. I can charge the battery overnight It will hold enough charge to start the truck. I only have enough to buy one of these items. I need to go to work tomorrow should I replace the alternator and drive to work or should I replace the battery

I had a bad battery couldn't buy a new one I kept recharging it now my alternator went bad. Could the bad battery be the cause?

My truck runs good but when I slow down to stop It just dies.I cant hear my engine run it doesn't make too much noise the only way I notice it quit is my RPM gauge goes to zero

I'm getting no heat could it be the heater coil or my thermostat.I have a 302 engine and it is not over heating.I can't afford to fix either How else can I defrost my windshield in cold and rainy weather?

My ford truck is leaking oil i was told to replace the rocker arm cover gaskets .I was going to do it myself but I dont know how to remove my fuel injection. Is it easy ? Can I screw it up?

When installing new brake pads in the front wheels is it ok to just compress the brake piston with a clamp with out bleeding the line?I"m doing it by myself and don't have any one to help me bleed the lines.Will it damage the master cylinder? P.S I already did it will my brakes work tomorrow?

Not a chance I scored higher and was trained as a cook