Recent content by Soft Talker

This thing will not go into overdrive. It shifts well except for not going to overdrive. Reverse is fine, no noise and everything is smooth. Any ideas??

What are the tow in specs for this P.U.? I have replaced the thie rod ends and need to set the tow in. Thanks

Replacing the ball joints on my 85 dodge pick up. The upper ball joint has an adjusting sleeve. What is the proper procedure for adjusting this sleeve? ball joints have already been pressed into the steering knuckle. I thought I would tighten the bottom joint nut first then adjust the sleeve...

Can I pull the intermediate axle on the left side without pulling the disconnect assembly? Any suggestions for reinstalling the axle shafts? I do not need to pull the inner axle shaft, all is OK here. The axle shaft on the right side does not seem to be a problem.