Recent content by joeron

i need to make new tread on the crankshaft hole,the bolt for that hole is 13.85mm. because the hole treads are strip i need to drill to a new size.my question is this.The hole is likely 13.90- 13.95mm.what size drill bit i need,and tap the biggest i got is 12x1.75 and is small? and what size new...

hello i have a 1992 Honda civic DX. 1.5L. 4 cyl.was driving the card and heard something broke.found the crankshaft pulley off and broken.the rod where the pulley goes in is damage out and in the tread,can't secure the bolt.will need to replace the crankshaft. i had work on this kind of...

i have a 1998 jeep cherokee sport. 6cyl.4.0L.after having noise from the driver side wheel when applying bake.i changed the brake pads,rotor,caliper.also purge the line to make sure there is no air.still when apply brake sharp on 25 and faster mile i get a sound like FRUUUUUUU.from the driver...

we have a 1999 jeep cherokee sport.in the morning or when the car is cold.i try to start the car and all it do is crank,will not run. the only way it will run is if i start the car with my foot on the gas pedal .after it runs if i release the gas pedal it goes off.when i make it run with my foot...

hello i have a 1992 honda civic dx 1.5L.with automatic transmission.when i drive the car i noticed that the speed change hard when it reach 35mph mark .at 15,25,55 MPH mark the speed change fine,but at 35 MPH mark the speed change hard with like a pull.it does it like 70 percent of time.beside...