Recent content by bestwrencher

you lost me here, we're talking brake lights on the back of some kind of car that dont light up unless you use hand brake? or dash brake light only comes on with hand brake( which is normal) Start over with the type of car and which lights you are concerned with, i could probably help

if you jumped and it started then battery is not charging, How did autozone test? were the parts taken to them or did they test in vehicle? they missed something, if altenater /battery were removed for testing then I'd expect to find fuse/wiring problem. If I took vehicle to them and they...

most likely a bearing is failing on whatever the belt is turning, usually that is water pump on that vehicle but some have fan on an idler pulley, either way whatever the pulley is driving needs to be replaced

low port is on the dryer, the fittings should be different enough so that you dont hook up to wrong one, but high side (the one you dont want to hook up to) is always between the compressor and condenser(radiator like thing)

yea, all that junk has to be removed out of the way, the bar has to be removed,that giant bolt has to be removed too, it disconnects battery so you dont short system(cause ground and power to contact, makes alot of sparks, damage) then there's the battery holddown to remove and then can pull out...

All full size cadillacs come with northstar since 94 and most are decent engines, some do get leaks from engine case half,(blocks split in half) and headgaskets, also had a torq convertor, turbine shaft seal problem with trans, but most problems should have been taken care of by ten years, any...

Bu Ku bucks, its 18 hours just to remove engine and thats not including dissassmebly and parts, yes the engine has to come out.

The S10 has so many years and engines that your question is too hard for me at this point, but if you have a check engine light start there, they also had fuel regulator leaks and some motors even had fuel lines inside intake

If there's no way to release adjuster and the drum is only held on by groove cut in drum by wear then you have to pry far enough to cut or break shoe retainers,buy hardware kit, but sometimes the access window for adjuster star is in the front of drum not necessarily thru the backing plate.