Recent content by acalex1967

All lights work fine except when you flip to the high beams, both lights flash in sequence, the same way a hazard (4 ways) would flash. And for what its worth, the cruise, horn and interior lights don't work either. Any ideas? We just bought the car over the weekend. Thanks!

Microwave is a Panasonic 2.2 Cubic foot 1300 watt Model number NN-S952WF unit that is about 8 years old. The unit runs for about 4 to 5 seconds then shuts off. I have taken the back casing off to inspect and fount a copper coil style relay cycling on and off. After it cycles the third time, it...

I have taken this car to 2 parts stores and no one can get me the right code or even get the scanner to work on it. I am hoping some Fox body mustang fans like myself can tell me what a common problem is so I can just not keep replacing stuff. The TPS has been replaced since that was damaged...

No one can read the code in my car with a scan tool, so I am trying to see if anyone has some suggestions. I have replaced the EGR sensor and the TPS as well. The light comes on when you start the car and goes out periodically as it fluctuates with the vehicles RPMs, but stays on mostly. Anyone...

Here are the codes: 34:EGR Valve Position/Pressure Feedback EGR Voltage Above Closed Limit (O,R), PFE or EVP circuit has intermittently failed above the closed limit of 0.67 volts (CM) 67: Park Neutral Position Switch Circuit Open; A/C On -Manual (O), Manual Lever Position Sensor Out Of...

Ok, Everyone has been really helpful so far, now I am going to attempt another feat of strength. My airbag light is flashing (duh) and I need to know how to check the code if there is one or if its just flashing because something is wrong? Thanks again!!

Ok, so everyone was really helpful telling me how to pull the codes for my car yesterday and I really appreciate it. Now my problem is I have no idea what they mean! I went to a few web sites and some of my codes arent even there!! So, here is what came up when I ran the test: KOEO results are...

I just bought a 1990 LX 5.0 Mustang and the fuel gauge is not working. here's the deal: All other gauges work, no fuses blown and the cluster is not the issue. I swapped it with my sons cluster from his 90 lx and same thing happened. Anyone have an idea what a common problem is with these so I...

Why are my headlight wire overheating at the switch on my 1989 Ford Mustang GT? I had to replace the old head light switch wiring harness, but copied all wires correctly. However now, when I turn on the headlights, the lead wire for the park lights and the lead wire for the head lights heat up...

Why wont my turn signals work on my 1989 Ford Mustang GT? Both flashers are good, all fuses are good, I cant figure it out! I had to replace a wiper switch governor so I had the cluster and wiring available, but they were working yesterday. Today, not so much. Any help would be appreciated. I am...

Why wont my door lock actuators work in my 1989 Ford Mustang GT? I cant find a listing for a fuse, all fuses are good, no listing for a relay and switch works. I bench tested both actuators and both work well. Any idea would be greatly appreciated.

Why wont my lock actuators work in my 89 Ford Mustang? All fuses are good, no listing for a relay and switchs all works. I bench tested both actuators and both work well. Any idea?

...Mustang GT? Can a 1991 Ford Mustang Speedometer Cluster and Bezel be used in a 1989 Ford Mustang GT? I have a 1989 Mustang GT that has a bad cluster and the some hillbilly hacked the bezel around it up as well. However, I have a cluster and bezel from a 1991 GT in excellent shape. Can I use...