Recent content by abdulwasiu

  1. A

    Why my mazda 626 1995 model smoke after packing it for long hours before starting it?

    However, If the oil is between F and L mark on the dip stick, no smoke will be seen.I have changed the valve seal. The car mileage is 260,000km Can you guys help me out?
  2. A

    Why my mazda 626 1995 model smoke after packing it for long hours before starting it?

    However, If the oil is between F and L mark on the dip stick, no smoke will be seen.I have changed the valve seal. The car mileage is 260,000km Can you guys help me out?
  3. A

    Why water always dry from the water tank of Mazda MPV 2001 model?

    I have just changed the top cylinder gasket of this car due to the above problem. Yet water still dry from the water tank after covering about 40km.The water line in the engine has been bled but yet to no avail. kindly help me out.
  4. A

    I just notice that my mazda 626 1995 mode bring out white smoke at the tail pipe in

    the morning and afternoon.? But the smoke stop after the car is warm. Kindly help me out with what can be done to stop this effect. Note: The car mileage is now 260000km. Thanks
  5. A

    My mazda 626 had its timing belt broken at 120km/h speed.?

    The belt size is 133M X 25 and it was replaced with 133M X 24. But after starting the engine,the following observations were made; 1. I have to press the accelerator pedal down before it can start. 2. The car can no longer run on idle speed. On these condition, I use the car to cover about...
  6. A

    How can I know the difference between bad valve seal and worn piston ring

    in Mazda 626 car engine? In a car A/C, I can I Know if the dyer of A/C system is bag?
  7. A

    I just changed my mazda 626(260,000km mileage) engine oil and oil filter....

    ...Afterwards, I observed the following? 1. After covering 450km, oil level on dip stick remains ok 2. But after covering 500km upwards, oil will start to drop i.e going below F on the dip stick. Kindly help me with solution on this problem. Note : Oil grade used is 20W - 50 ( AP visco 2000)
  8. A

    Does weak valve seal have effect on my mazda 626 engine?

    If yes, what are the effects apart from smoke via the tail pipe. Thanks
  9. A

    how can know if my mazda 626 O2 sensor need replacement? Does it require a schedule...

    ...change? The car has covered 255500km.
  10. A

    I'm using Mobil1(0-40W) 4 my high mileage mazda 626 and as per rule, I'm to...

    ...replace the oil after 15,000miles? But I base in Lagos,Nigeria, West Africa where ambient temp. use to btw 35 to 42 deg at peak. Moreso I can be in traffic hold up for more than three hours with my car A/C working. Can you pls advice me on how many miles I should change my engine oil based on...
  11. A

    when my car mazda 626 1994 model is not engage with gear, the engine rpm

    will be 1.2x1000.? But when I reduced to 0.5 X 1000rpm, the engine will off itself any time the A/C compressor want pick. Pls kindly help me out. As a result, my car consume up to 22litres/100km.
  12. A

    Kindly help me out as my mazda 626 is consuming too much of fuel.?

    I noticed that in the morning if I start my car I do perceive odour of petrol.
  13. A

    Kindly help me out as my mazda 626 is consuming too much of fuel.?

    I noticed that in the morning if I start my car I do perceive odour of petrol.
  14. A

    What can be the cause? My hand brake stopped working after my mechanic replaced my

    mazda 626 back brake pad.? Guys help me out
  15. A

    what high milage oil can i use for my mazda 626 operating at an ambient temp. of 30

    to 45 deg. celcius? pls help me out
See more
Back
Top